HDZero Whoop V2 VTX

The HDZero Whoop V2 VTX is the next step up from the Whoop Lite — built for pilots who want the same low-latency HDZero video, now with better durability, reliability, and far easier installation.

It works with every HDZero MIPI camera and supports 540p90, 720p60, and 1080p30, delivering clean HD video at up to 200 mW over 5.8 GHz. A thicker PCB shrugs off the impacts that were the Whoop Lite's weak point, a factory-soldered harness with a Betaflight-standard digital VTX plug makes wiring almost plug-and-play, and a brass antenna retention bar locks the U.FL connector down through crashes and vibration. At just 31 × 31 mm with a 25.5 × 25.5 mm (M2) mounting pattern, it drops into anything from 80 mm whoops to 4-inch micro builds.

Key Features

• Works with all HDZero MIPI cameras (540p90 / 720p60 / 1080p30)
• Switchable 25 mW / 200 mW output, low-latency HD over 5.725–5.850 GHz
• Thicker ~1.6 mm PCB for real impact resistance
• Pre-soldered harness with Betaflight-standard digital VTX plug — minimal soldering
• Brass antenna retention bar secures the U.FL connector against crashes and vibration
• Compact 31 × 31 mm footprint, 25.5 × 25.5 mm (M2) mounting
• Wide 3–12.6 V (1S–3S) power input
• MSP OSD / Smart Audio control

Specifications

Important Notes

• No reverse-polarity protection — incorrect wiring will permanently damage the unit.
• When powering from a 5 V pad, make sure at least 1.5 A is available.
• On direct 1S power, voltage can dip below 3 V during throttle punch-outs and cause video loss.
• An external capacitor is recommended for 3S setups.

Box Contents

• HDZero Whoop V2 VTX ×1
• Power / UART Cable ×5
• Zip Ties ×2
• Rubber Grommet (M3 to M2) ×4
• U.FL Antenna Retention Screws ×3
• Metal Bar ×1

*Antenna not included.